Protocol log
AllStar uses IAX2 REGREQ/REGAUTH/REGACK to authenticate with the network register server, then NEWCALL to dial the target node. The handshake uses MD5(challenge+password).
DNS resolve register server—
TX REGREQ → callsign + node#—
RX REGAUTH ← challenge token—
TX AUTHREP → MD5(challenge+password)—
RX REGACK ← registered ✓—
TX NEWCALL → target node—
RX ACCEPT ← codec confirmed—
TX LAGRQ / RX LAGRP — latency measured—
Link active — ready—
Connect to see authentication detail.
Not connected — no link data.
AllStar link commands (send via DTMF):
*1XXXXX = connect node *2XXXXX = monitor *3XXXXX = disconnect
*70 = reconnect last *99 = disconnect all *80 = node status
*1XXXXX = connect node *2XXXXX = monitor *3XXXXX = disconnect
*70 = reconnect last *99 = disconnect all *80 = node status
Keyboard: type digits when PTT is active.
*1 + node# = connect *3 + node# = disconnect
*1 + node# = connect *3 + node# = disconnect